7 - 1
Section C Electrics
9803/6410
Section C
7 - 1
Issue 1
Revolution Sensor
Revolution Sensor Removal and
Installation
1 Prepare the Machine
Position the machine on level ground.
Stop the engine and remove the starter key.
2 Locate the Flywheel housing
a The flywheel housing is machined to accommodate
the sensor.
b Remove the sensor by unscrewing it.
Note: Check the 'O'-ring for damage or wear, replace if
necessary.
3 Installation is by screwing the sensor in the machined
section at a torque of 44.13-53.0 Nm(33-40 lb ft).
Note: The clearance between the sensor and the flywheel is
3.1 +0.4 mm.
To Next Page
Loading...
Need help?
General
