9 - 2
Replacement
1. Before fitting the roller, add the specified oil (see Section
3). Install plug using an appropriate pipe thread sealant.
2. With the track supported as shown under Removal,
install the roller. Apply Loctite 262 to the threads and fit
the mounting bolts.
3. Remove the wooden blocks and jack.
4. Apply grease through the check valve to adjust the track
tension (see "Checking/Adjusting the Track Tension).
Section J
Track and Running Gear
9803/6400
Section J
9 - 2
Issue 1
Top Roller (continued)
To Next Page
Loading...
Need help?
General
