29
8 ETHERNET TCP/IP Interface
The TCP/IP interface has two essential functions.
Firstly, HTML5-WebMotion can be accessed over the
Ethernet TCP/IP interface. Secondly, the Ethernet
TCP/IP interface is used to control the axis with all
available ASCII commands. The port 10001 I used for
ASCII commands.
IP-address of XENAX® is provided on the back side of
the controller. If this has been changed or the label is
not accessible, you can have the IP-address displayed
on the 7-segmet display. To do this, switch on the
logic supply and switch it off again while the dot on
the 7-segment display is blinking. The next time you
switch it on, the IP-address is shown on the 7-
segment display.
Connection of XENAX® to laptop/PC over a normal
RJ45 network cable.
When connecting laptop/PC directly without a switch
to XENAX®, it may need a crossed RJ45 cable.
However, with newer network types a crossed RJ45
cable is not necessary anymore.
Display Ethernet Plug
To Next Page
Loading...
Need help?
General
