11 General Section
PCM9X II Transmitter Features (Internal)
Control Stick Tension Adjustment
Remove the six transmitter back screws as shown on
the previous page. Remove the transmitter back, being
careful not to cause damage to any components.
Adjust each screw for desired tension (counter-
clockwise to loosen stick feel; clockwise to tighten stick
feel). When adjusting the throttle ratchet tension, make
sure that the adjusting screw does not touch the PC
board after adjustment is complete.
Rudder
Tension Screw
Elevator
Tension Screw
To Next Page
Loading...
