– 17 –
(1) Installing the connecting rod
1) Move pedal ❸ to the right or left as illustrated
by the arrows so that motor control lever ❶ and
connecting rod ❷ are straightened.
(2) Adjusting the pedal angle
1) The pedal tilt can be freely adjusted by changing
the length of the connecting rod ❷.
2) Loosen adjust screw ❹, and adjust the length of
connecting rod ❺.
27. Adjustment of the pedal
WARNING :
Be sure to turn the power OFF before the following work in order to prevent personal injury due to
unintentional starting of the sewing machine.
❶
❷
❺
❸
❹
28. Marker dots on the handwheel
❸
(Red)
❷
(White)
❶
The upper stop position of the needle bar is reached
when marker dot ❶ on the cover is aligned with
white marker dot ❷ on the handwheel.
The operating timing of the thread trimming cam is
when marker dot ❶ on the cover is aligned with red
marker dot ❸ on the handwheel.
To Next Page
Loading...
Need help?
General
