– 3 –
II. SET-UP
1. Installation
1) Carry the sewing machine with two persons as
shown in the gure above.
2) Do not put protruding articles such as the screw-
driver and the like at the location where the
sewing machine is placed.
3) Adjust so that the oil pan is supported at the four
corners of the table. Mount rubber hinge seat ❽
on the table and x it on the table with a nail.
4) Two rubber seats ❶ for supporting the head por-
tion on the operator side A are xed on the ex-
tended portion of the table by hitting the nail ❷ ,
and the other two rubber cushion seats ❸ on the
hinge side B are xed by using a rubber-based
adhesive. Then, oil pan ❹ is placed.
5) Fit knee lifter pressing rod ❻. Fit hinge ❼ into the opening in the machine bed, and t the machine head
to table rubber hinge ❽ before placing the machine head on cushions ❾ on the four corners.
6) Securely attach head support rod to the table until it goes no further.
1. Be sure to install the machine head support bar supplied with the unit.
2. If a pair of scissors or the like is caught between the control box and the table, the control
box cover can break. To prevent such an accident, do not place anything on C section.
Do not hold the handwheel.
❼
❽
❶
❶
❸
❸
❽
❶
❷
❹
❸
A
B
19.5mm
23.5mm
❼
❻
❾
C
To Next Page
Loading...
Need help?
General
