KE2000 Installation Manual
3
2. Installing the main unit
<Procedure>
1. Screw-in the adjusters to place the casters on the floor (ground) firmly before
transporting or moving the main unit.
2. Before moving the main unit using a forklift, be sure to put the fork under the main
unit from its front, and lift it up and move it after checking that the fork protrudes
sufficiently from the rear of the main unit.
<CAUTION>
1. When moving the main unit using a forklift, pay special attention to the load
center mark. (This caution also applies when using a pallet truck.)
2. Do not move the main unit using a forklift with the vision monitor and signal light
mounted. (This caution also applies when using a pallet truck.)
Signal light
Vision monitor
Load center mark
Caster
Adjuster
To Next Page
Loading...
Need help?
General
