11
3-13. Handling the cords
1) Bring the cords under the table into the control
box.
2) Put the cord brought into the control box through
cord exit plate
and x cable clip band
.
Arrange the cord so that it is not tensed
or hitched even when the machine head is
tilted. (See A section)
DANGER :
To prevent personal injuries caused by electric shock hazards or abrupt start of the sewing
machine, carry out the work after turning OFF the power switch and a lapse of 5 minutes or more.
To prevent accidents caused by unaccustomed work or electric shock, request the electric expert
or engineer of our dealers when adjusting the electrical components.
3) Install control box lid
with four setscrews
.
A
To Next Page
Loading...
Need help?
General
