IMPORTANT
SAFETY
INSTRUCTIONS
------------
-
Putting sewing systems into operation is prohibited until it has been ascertained that the sewing systems in which these
sewing machines will be built-in conform with the EC Council Directives Machinery. Technical service for those sewing
systems is also prohibited.
PI.
Observe the basic safety measures, including, but not limited to the following ones, whenever you use the machine.
2.
Read all the instructions, including, but not limited to this lnstruction Manual before you use the machine. In addition,
keep this lnstruction
~anlfal so that you may read it at anytime when necessary.
1
3. Use the machine after it has been ascertained that it conforms with safety ruleslstandards valid in your country.
4.
All safety devices must be in position when the machine is ready for work or in operation. The operation without the
specified safety devices is not allowed.
5.
This machine shall be operated by appropriately-trained operators.
6.
For your personal protection, we recommend that you wear safety glasses.
7. For the following, turn off the power switch or disconnect the power plug of the machine from the receptacle.
7-1 For threading
needle(s), looper, spreader etc. and replacing bobbin.
7-2 For replacing
part(s) of needle, presser foot, throat plate, looper, spreader, feed dog, needle guard, folder, cloth
guide etc.
7-3
For repair work.
7-4
When leaving the working place or when the working place is unattended.
7-5
When using clutch motors without applying brake, it has to be waited until the motor stopped totally.
8.
If you should allow oil, grease, etc. use with the machine and devices to come in contact with your eyes or skin or
P
9.
Tampering with the live parts and devices, regardless of
exceptions are described in the "explanation of application" in standard sheet EN501
10.
10.
Repair, remodeling and adjustment works must only be done by appropriately trained technicians or specially skilled
personnel. Only spare parts designated by JUKl can be used for repairs.
11.
General maintenance and inspection works have to be done by appropriately trained personnel.
12.
Repair and maintenance works of electrical components shall be conducted by qualified electric technicians
or
under
the audit and guidance of specially skilled personnel.
Whenever you find a failure of any of electrical components, immediately stop the machine.
13. Before making repair and maintenance works on the machine equipped with pneumatic parts such as an air cylinder,
the air compressor has to be detached from the machine and the compressed air supply has to be cut off. Existing
residual air pressure after disconnecting the air compressor from the machine has to be expelled. Exceptions to this
are only adjustments and performance checks done by appropriately trained technicians or specially skilled
personnel.
14.
Periodically clean the machine throughout the period of use.
---
A
--
--
to a grounded receptacle.
16. An appropriate power plug has to be attached to the machine by electric technicians. Power plug has to be connected
---
-
18. Remodel or modify the machine in accordance with the safety rules/standards while taking all the effective safety
r19. Warning hints are marked with the two shown symbols.
-
I
Danger of injury to operator or service staff
n
Items requiring special attention
I
To Next Page
Loading...
Need help?
General
