JUKI SC-510 User Manual

ENGLISH
– 1 –
1
2
3
!
. SPECIFICATIONS
@
. SET-UP
Install the motor unit to the control box following the instructions below.
1. Installing the motor unit
Spring
washer
Nat
Convex
washer
(Caution) 1. Indication of the power consumption is the mean power consumption when LU-1520N-7 is mounted
in accordance with the operating conditions JUKI species. The power consumption changes in
accordance with the operating conditions and the mounted machine head. So, be careful.
2. Instantaneous maximum power consumption may become 1.5 times or more than the mean power
consumption.
Install the motor unit on the table with the tting bolt
asm. supplied with the unit as accessories.
At this time, insert the nuts and washers supplied
with the unit as accessories as shown in the gure
so that the motor unit can be securely xed on the
table.
1) Press three bolts
1
supplied with the unit as ac-
cessories into the motor hanging bolt hole in the
table and x them.
2)
Temporarily tighten convex washer, spring
washer and nut on the side where two bolts are
attached.
3) Hang the motor unit to the washer which has
been temporarily tightened, and attach convex
washer, spring washer and nut to the other bolt
on the opposite side.
4)
After adjusting the installing position of the motor,
securely tighten the respective nuts.
2. Installing the control box
1) Loosen four screws
2
supplied with the mo-
tor unit as accessories, tighten screws
2
after
hanging control box unit
3
to the screws, and x
control box unit
3
.
Supply voltage Single phase 100 to 120V /
3-phase 200 to 240V
Single phase 200 to 240V
Frequency 50 Hz / 60 Hz 50 Hz / 60 Hz
Operating environment Temperature : 0 to 40˚C
Humidity : 90% or less
Temperature : 0 to 40˚C
Humidity : 90% or less
Power consumption 425VA 425VA

JUKI SC-510 Specifications

General

Brand	JUKI
Model	SC-510
Category	Sewing Machine
Language	English