–
26 –
Maintenance and lubrication
CAUTION
Always must be disconnected plug from socket-outlet before cleaning or
lubricat ing the sewing machine.
Cleaning the hook
● Turn OFF the power switch. Remove the needle.
● Loosen the screws to remove the throat plate.
● Then clean up the hook components using a cleaning brush.
1
2
Lubricating the machine
Bring the red marker dot to the right front.
The sewing machine can be lubricated in two different methods. Select one of the two methods for lubrication.
● Use the machine oil (New Defrix Oil No.1 or similar) supplied with the machine.
● After the lubrication, turn the handwheel by hand to allow the oil to spread in the whole hook.
● For daily use, lubricate the sewing machine once a day.
● After unpacking or after the sewing machine remained unused for an extended period of time, apply a larger quantity of oil (ve
to seven drops) than usual. If the quantity of oil is excessive, oil can drop on the material. Take care not to apply an excessive
quantity of oil to the needle bar and the hook section.
● After the lubrication, carry out trial stitching without exceptions.
1
2
1. Lubricate the machine after removing the bobbin case.
2. Turn the handwheel so that its red marker dot comes to the right front as viewed from just beside the sewing machine.
3. Apply one or two drops of oil to the hole indicated by the arrow.
1. Lubricate the machine after removing the bobbin case.
2. Apply one or two drops of oil to the arrowed sections shown in the gure.
1. If oil gets in eyes, immediately rinse the oil
out with water. If you swallow oil by mistake,
immediately consult a medical doctor.
2. Keep this machine away from children.
3. Waste oil disposal is legally obliged. Dispose
of the waste oil according to the relevant
legislation.
CAUTION
To Next Page
Loading...
Need help?
General
