JUKI TL-98Q Service Manual

– 3 –
[2] Names of Components
[3] Disassembly/assembly
Page
Outer Components
1. Arm cover asm. ...................................... 4
2. Belt cover and motor cover .................... 4
3. Face plate asm. ...................................... 4
4. Bed cover mas. asm. .............................. 5
5. MAIN circuit board asm. ......................... 5
Function components
1. Motor asm. and transformer asm. .......... 5
2. Handwheel and clutch ............................ 6
3. Thread tensioner asm. ........................... 6
4. Presser bar ............................................. 7
5. Needle bar .............................................. 7
6. Thread take-up ....................................... 8
7. Reverse feed stitch lever ........................ 8
8. Idler ........................................................ 8
9. Stitch dial ................................................ 9
10. Automatic thread trimming switch case .. 9
Page
11. Wire holder ............................................. 9
12. Knee lifter lever ..................................... 10
13. Hook driving shaft pulley ......................... 12
14. Hand lifter lever ..................................... 13
15. Drop-feed knob ..................................... 14
TL-98Q
Automatic thread trimming components
1. Looper mas. asm. ................................. 15
2. Moving knife arm
installing plate mas. asm. ..................... 15
3. Moving knife base mas. asm. ................. 16
4. Thread trimming solenoid mas. asm. ..... 16
Indicating needle of
presser spring regulator
Face cover
Pressure indicating plate
Thread take-up thread guide
Lamp switch
Thread take-up spring
Presser bar connection thread guide
Lamp bulb
Hand lifter lever
Needle bar thread guide
Needle bar thread bracket
Presser spring regulator
(Hole for auxiliary table support plate)
Thread guide base
Side cover
Thread guide No.1
Standard presser foot asm.
Arm cover asm.
Throat plate asm.
Bobbin winder shaft
Thread take-up spring adjusting plate
Belt cover
Handwheel
Stitch dial
Needle up/down switch
Automatic thread trimming switch
Reverse feed stitch lever
Hole for knee lifter lever setting
Bed cover rubber seat
Bed cover
Drop-feed knob
(Hole for auxiliary table support plate)
Thread guide rod
Needle threader lever

JUKI TL-98Q Specifications

General

Brand	JUKI
Model	TL-98Q
Category	Sewing Machine
Language	English