Juniper J-series Services Router J2320 User Manual

You can change the default behavior of the RESET CONFIG button. For more
information, see the J-series Services Router Basic LAN and WAN Access Configuration
Guide.
Built-In Gigabit Ethernet Ports
Four built-in Gigabit Ethernet ports provide LAN connections over copper interfaces
to hubs, switches, local servers, and workstations. You can also designate an Ethernet
port for management traffic. When configuring one of these ports, you use the
interface name that corresponds to the port’s location. From left to right on the front
panel, the interface names for the ports are ge-0/0/0, ge-0/0/1, ge-0/0/2, and
ge-0/0/3.
For Gigabit Ethernet port pinout information, see “Gigabit Ethernet uPIM RJ-45
Connector Pinout” on page 235.
Each port has two LEDs, a TX/RX LED on the left side and a LINK LED on the right
side. Table 10 on page 23 describes the built-in Ethernet port LEDs.
Table 10: Gigabit Ethernet Port LEDs
DescriptionStateColorFunction
Port is online.On steadilyGreen
LINK
Port is offline.OffUnlit
Port is transmitting or receiving data.BlinkingGreen
TX/RX
Port might be online, but it is not receiving data.OffUnlit
Console Port
You can use the console port on the chassis front panel to connect to the Routing
Engine through an RJ-45 serial cable. From the chassis console port, you can use the
CLI to configure the router. The console port is configured as data terminal equipment
(DTE) and supports the RS-232 (EIA-232) standard.
For information about securing the chassis console port, see the J-series Services
Router Administration Guide.
For pinout information, see “Chassis Console Port Pinouts” on page 236.
AUX Port
The port labeled AUX on the front panel of the J-series Services Router is for future
use and is not activated.
J2320 and J2350 Services Router Hardware Features ■ 23
Chapter 2: System Overview

Juniper J-series Services Router J2320 Specifications

General

Brand	Juniper
Model	J-series Services Router J2320
Category	Network Router
Language	English