EasyManuals Logo

Jura IMPRESSA E85 User Manual

Jura IMPRESSA E85
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
10. Drawing off pre-ground coffee
Never use instant coffee or quick-coffee. We recommend
that you always use powder from fresh coffee beans or, pre-
ground, vacuum-packed coffee. Never fill in more than 2
portions of powder. The pre-ground coffee tank is no storage
tank. Make sure that the pre-ground you use is not too fine.
This may cause blocking of the system. In this case the
coffee only drips out of the coffee spout.
If you have filled in too little powder, the message NOT
ENOUGH POWDER will be displayed. The IMPRESSA
E80/85 stops the operation and returns to "ready for draw
off" mode.
You can stop the draw-off operation at any time by pressing
any coffee draw-off key.
READY
Put 1 or 2 cups under the adjustable coffee spout (18).
Open the cover of the filler funnel for pre-ground coffee (12).
Press the powder coffee selection key (5).
FILL
POWDER
Fill 1 or 2 level spoonfuls of pre-ground coffee in the filler
funnel for pre-ground coffee (12) (Fig. 11) and close the cover.
Press the required draw-off key for 1 cup (6) or 2 cups
(4)
120 ML (water quantity last adjusted)
The illuminated ring (2) is active.
POWDER
Turn the Rotary Switch (1) again to select the water quantity in-
dividually:
For Example: 210 ML
POWDER
Your product is being prepared.
READY
11. Drawing off hot water
If you do not change the settings using the Rotary Switch
(1), the water quantity last adjusted will be drawn off auto-
matically.
Install the hot water jet (see Fig. 5) to obtain perfect water
flow. Do not replace the replaceable hot water jet (17)
directly after drawing off water, because the nozzle is hot
after the draw-off operation.
At the start of the water draw-off operation there can be
splashing Avoid direct contact with the skin!
READY
Place a cup under the replaceable hot water jet (17).
Open the steam / hot water draw-off tap (15) (Fig. 13).
The illuminated ring (2) is active.
For example: 140 ML
WATER
Adjust the required water quantity by turning the Rotary Switch
(1).
For example: 200 ML
WATER
If the required water quantity is reached, the following message
is displayed:
SHUT TAP
Close the steam / hot water draw-off tap (15).
READY

Table of Contents

Other manuals for Jura IMPRESSA E85

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jura IMPRESSA E85 and is the answer not in the manual?

Jura IMPRESSA E85 Specifications

General IconGeneral
TypeAutomatic Coffee Machine
Pump Pressure15 bar
Power1450 W
Adjustable Coffee StrengthYes
Adjustable Water AmountYes
ProgrammableYes
Milk FrotherYes
Programmable Coffee StrengthYes
Programmable Water VolumeYes
Pre-Brew Aroma SystemYes
Cleaning and Descaling ReminderYes
Energy Saving ModeYes
ColorBlack
Water Tank Capacity1.9 liters

Related product manuals