8
Fill the water tank (11) with fresh water.
OPEN TAP
Place an empty cup under the replaceable hot water nozzle (17).
Open the steam / hot water draw-off tap (15) (Fig. 13).
FILLING
SYSTEM
SHUT TAP
Close the steam / hot water draw-off tap (15).
HEATING
PRESS
RINSE
Press the maintenance key (9).
Machine carries out a rinsing operation.
RINSING
READY
If BEANS FILL is displayed, press the coffee draw-off key
again. Machine not filled with coffee beans yet.
To get an excellent froth, adjust the coffee spout (18) to the
size of your cup (Fig. 3).
4. Adjusting the water hardness
Water is heated in the IMPRESSA E80/85. As a result, cal-
cification occurs during normal use and is indicated auto-
matically. Before using the IMPRESSA E80/85 for the first
time the hardness of the water used must be adjusted. Use
the supplied test sticks for this.
1° German hardness is equivalent to 1.79° French hardness.
If the filter is activated, the program step Water Hardness no
longer appears.
The IMPRESSA E80/85 has 5 hardness degrees which can
be used and are displayed while you are adjusting the water
hardness.
The displayed information means the following:
LEVEL –– Water hardness function switched off
LEVEL 1 German water hardness degree 1 to 7°
French Water hardness degree 1.79 – 12.53°
LEVEL 2 German water hardness degree 8 to 15°
French Water hardness degree 14.32 – 26.85°
LEVEL 3 German water hardness degree 16 to 23°
French Water hardness degree 28.64 – 41.14°
LEVEL 4 German water hardness degree 24 to 30°
French Water hardness degree 42.96 – 53.7°
When the IMPRESSA E80/85 leaves the factory it is adjusted to
LEVEL 3. You can adjust another hardness. To do this, proceed as
follows:
READY
Press the programming key (3).
Illuminated ring (2) is active.
FILTER –
Turn the Rotary Switch (1) until the following message is dis-
played:
HARDNESS
Now press the Rotary Switch (1) to start the programming.
LEVEL 3
Turn the Rotary Switch (1) until the required level is displayed.
For example, LEVEL 4
To Next Page
Loading...
