6
Precautions Prior to Use of Calibration
• Calibrated result might be different from the factory default data, depending on the operating environment.
• During calibration, set the PC to the administrator mode, and disable the screen mode and energy-saving mode of
the PC.
• After turning on the power of the projector, set to the Picture Mode for performing calibration. Start calibration after
waiting for about 30 minutes.
• Make sure the brightness of the ambient light in the room is the same as that of the operating environment where the
projector is used.
• Do not cast a strong ambient light directly on the screen.
• Set the “ECO Mode” of the projector to “OFF” when the calibration software is
running.
• Do not use the remote control and the operation panel when the calibration
software is running.
• Make sure to input video signals (1080 or 720) when the calibration software is running. Calibration does not work
with 4K input.
• Do not set to the HIDE mode when the calibration software is running.
• The calibration does not work when displaying 3D image.
• Calibration does not work when Color Profile has been set to Off or x.v.Color. Set to other Color Profile before
performing the calibration.
• Calibration does not work when Lens Aperture has been set to “Auto 1” or “Auto 2”. Set the lens aperture to "Manual"
before performing the calibration.
• To set the environment settings by using the calibration software, turn off the environment setting of the projector.
• If an error message is prompted while using the calibration software, close the application and restart the projector.
Wait at least 5 minutes before restarting.
• If the application is ended due to the error message while backup, importing or exporting is in progress, restart the
PC, and perform the operations again.
* Upon saving the data after performing calibration, a backup file will be saved automatically to the folder selected in
“Setting”. All data of the projector set prior to this process will be overwritten.
Calibration Adjustment
MENU
BACK
LAN
A
Back
Operate
Select
Exit
Function
Lamp Reset
Remote Code
Communication Terminal
Off
ECO Mode
Off
Off
Off
High Altitude Mode
Network
Off Timer
Trigger
JVC_PCS_manual.fm 6 ページ ２０１４年７月２９日 火曜日 午後６時５０分
To Next Page
Loading...
Need help?
General
