3
Pre-installation Check
Before starting the installation, ensure that no program is running.
During installation or calibration, set the PC to the administrator mode, and disable the screen mode and energy-
saving mode of the PC.
Do not connect the optical sensor to the PC before installing the driver.
Installing Software
Double-click the download file “JVC_PJ_Calibration5_en_v***.zip” to start installation. Download the file to a directory,
and unzip the file.
The following file is created.
● “JVC_PJ_Calibration5_v***.msi”
Double-click “JVC_PJ_Calibration5_v***.msi” to start installation.
1 “Welcome to the Projector Calibration Software Setup Wizard” window appears. Click the [Next] button.
2 “Select installation Folder” window appears. You can proceed to the next step with the destination unchanged,
or designate a folder if necessary.
3 “Confirm installation” window appears. Click the [Next] button.
4 After installation is complete, an “Installation complete” window appears. Click the [Close] button to exit the
wizard. Check to ensure that short-cut icons are automatically created both in the Start menu and on the
Desktop.
Caution
* This software does not run on its own. To run the program, you need to connect the optical sensor to a PC via USB
cable, and the PC to a projector via LAN cable.
Installing the Optical Sensor Driver
Install the software supplied with Spyder4ELITE/PRO,
For details on how to install, refer to the instruction manual that is bundled with the optical sensor unit.
Do not run the Spyder4 software when using this calibration software.
Preparation for the Calibration Adjustment
Installing the Software
JVC_PCS_manual.fm 3 ページ ２０１４年７月２９日 火曜日 午後６時５０分
To Next Page
Loading...
Need help?
General
