JVC GR-D820EK User Manual

44 EN
Connections/Editing
It is also possible to copy recorded scenes from
the camcorder onto another video unit
equipped with a DV connector. Since a digital
signal is sent, there is little, if any, image or
sound deterioration.
Make sure all units are turned off.
Connect this camcorder to a video unit
equipped with a DV input connector
using a DV cable as shown in the
illustration.
Start playback on the camcorder
(墌 23).
At the point you want to start dubbing,
start recording on the video unit. (Refer
to the video unit’s instruction manual.)
To stop dubbing, stop recording on the
video unit, then stop playback on this
camcorder.
Notes:
● It is recommended to use the AC Adapter as
the power supply instead of the battery pack
(墌 18).
● If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not
dubbed.
● Even though the DV cable is connected
correctly, sometimes the image may not appear
in step . If this occurs, turn off the power and
make connections again.
● If “Playback Zoom” (墌 25) or “Playback Special
Effects” (墌 25) is attempted or SNAPSHOT is
pressed during playback, only the original
playback image recorded on the tape is output
from the DV OUT connector.
● When using a DV cable, be sure to use the
optional JVC VC-VDV204U or VC-VDV206U DV
cable.
Dubbing To A Video Unit
Equipped With A DV
Connector (Digital Dubbing)
Core Filter
To DV OUT
DV Cable (optional)
To DV IN
Video unit equipped with DV connector
1
1
1
1
2
2
2
2
3
3
3
3
4
4
4
4
5
5
5
5
4
4
4
4
Connections/Editing
GR-D820EK_GR-D860EK.book Page 44 Monday, November 19, 2007 10:15 AM

JVC GR-D820EK Specifications

General

Brand	JVC
Model	GR-D820EK
Category	Camcorder
Language	English