JVC GR-D860EK User Manual

46 EN
Connections/Editing
The audio track can be customised only when
recorded in the 12-BIT and SP modes (墌 33).
● Use the provided remote control.
Play back the tape to locate the point
where editing will start, then press
PAUSE (9).
While holding A. DUB (D) on the
remote control, press PAUSE (9). The
“9D” indicator appears.
Press PLAY (U), then begin “narrating”.
Speak into the microphone.
● To pause dubbing, press PAUSE (9).
To end Audio Dubbing, press PAUSE
(9), then STOP (8).
To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX” (墌 36).
Notes:
● Sound is not heard from the speaker during
Audio Dubbing.
● When editing onto a tape that was recorded at
12-BIT, the old and new soundtracks are
recorded separately.
● If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only
edit recorded areas.
● If feedback or howling occurs during TV
playback, move the camcorder’s microphone
away from the TV, or turn down the TV’s
volume.
You can record a new scene into a previously
recorded tape, replacing a section of the
original recording with minimal picture
distortion at the in and outpoints. The original
audio remains unchanged.
● Use the provided remote control.
Notes:
● Before performing the following steps, make
sure that “TIME CODE” in both Recording and
Playback Menus is set to “ON”
(墌 22, 36).
● Insert Editing is not possible on a tape recorded
in the LP mode or on a blank portion of a tape.
Play back the tape, locate the Edit-Out
point and press PAUSE (9). Confirm the
time code at this point (墌 22).
Press REW ( 3 ) until the Edit-In point
is located, then press PAUSE (9).
Press and hold INSERT (I) on the
remote control, then press PAUSE (9).
The “9I” indicator and the Time Code
(min.:sec.) appear and the camcorder
enters Insert-Pause mode.
Press START/STOP to begin editing.
● Confirm the insert at the time code you
checked in step .
● To pause editing, press START/STOP.
Press it again to resume editing.
To end Insert Editing, press START/
STOP, then STOP (8) on the remote
control.
Notes:
● Program AE, Effects and Shutter Effects (墌 41)
can be used to spice up the scenes being
edited during Insert Editing.
● During Insert Editing, the date and time
information changes.
● If you perform Insert Editing onto a blank space
on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
● During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops.
Audio Dubbing
GR-D860
PAUSE
PLAY
A.DUB
STOP
REW
INSERT
START/
STOP
Stereo
Microphone
1
1
1
1
2
2
2
2
3
3
3
3
4
4
4
4
Insert Editing
GR-D860
1
1
1
1
2
2
2
2
3
3
3
3
4
4
4
4
1
1
1
1
5
5
5
5
Connections/Editing
GR-D820EK_GR-D860EK.book Page 46 Monday, November 19, 2007 10:15 AM

JVC GR-D860EK Specifications

General

Brand	JVC
Model	GR-D860EK
Category	Camcorder
Language	English