EasyManuals Logo
Home>JVC>Camcorder>GR-DVL820

JVC GR-DVL820 User Manual

JVC GR-DVL820
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
EN
69
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the
beginning.
The power is not connected
properly.
The battery is dead.
The date/time is not set.
The built-in clock battery has run
out and the previously set date/time
has been erased.
— For Tape Recording —
The tape’s erase protection tab is
set to “SAVE”.
The Power Switch is set to “PLAY”
or “OFF”.
The VIDEO/MEMORY Switch is set
to “MEMORY”.
“TAPE END” appears.
The cassette holder cover is open.
— For Memory Card Recording —
The VIDEO/MEMORY Switch is set
to “VIDEO”.
The camcorder is not getting power,
or some other malfunction exists.
Focus is set to the Manual mode.
The recording was done in a dark
place, or the contrast was low.
The lens is dirty or covered with
condensation.
Connect the AC Adapter securely
(Z pg. 9).
Replace the dead battery with a
fully charged one (Z pg. 8, 9).
Set the date/time (Z pg. 11).
Consult your nearest JVC dealer
for replacement.
Set the tape’s erase protection tab
to “REC” (Z pg. 12).
Set the Power Switch to “
AUTO
” or
MANUAL
” (Z pg. 17).
Set the VIDEO/MEMORY Switch to
“VIDEO”.
Replace with new cassette
(Z pg. 12).
Close the cassette holder cover.
Set the VIDEO/MEMORY Switch to
“MEMORY”.
Turn the camcorder’s power off and
on again (Z pg. 17).
Set Focus to the Auto mode
(Z pg. 43).
Clean the lens and check the focus
again (Z pg. 74).
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
1 No power is supplied.
2 “SET DATE/TIME!” appears.
3 Recording cannot be
performed.
4 There is no picture.
5 The focus does not adjust
automatically.
CONTINUED ON NEXT PAGE
TROUBLESHOOTING

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC GR-DVL820 and is the answer not in the manual?

JVC GR-DVL820 Specifications

General IconGeneral
BrandJVC
ModelGR-DVL820
CategoryCamcorder
LanguageEnglish

Related product manuals