Blinking of the Tally Lamp
The tally lamp start blinking when the remaining space on the SD card is running out during recording, or
when the battery power is running low.
(Common for front and back tally lamps)
Blinking Mode Remaining Battery Power/SD Card Space
Blinks slowly
(once every second)
0
Battery power is low
0
Remaining recording time on SD card is less than 3 minutes (during
recording)
0
When a malfunction occurred during live streaming
Blinks quickly
(2 times per second)
0
Remaining battery power is almost zero
0
Remaining recording time on SD card is zero (during recording)
0
Error on the camera recorder
Warning Tone
0
Warning tone is output from the monitor speaker and [PHONES] terminal when the battery level is low.
0
Warning tone is also output when an error occurs in the camera recorder.
Memo :
0
You can specify whether to turn on the warning tone as well as setting the volume in [A/V Set] B [Audio
Set] B [Alarm Level].
(A P129 [ Alarm Level ] )
Troubleshooting
Symptom Action
Power does not turn on.
0
Is the power supply or battery properly connected?
0
Is the battery charged?
0
Is the power turned on immediately after it is turned off?
Make sure to wait for an interval of at least 5 seconds before turning
on the power again.
Unable to start recording.
0
Is the record trigger button/lock switch on the handle turned on?
0
Is the write-protect switch of the SD card turned on?
Make sure that the write-protect switch is turned off.
(A P43 [Write-Protect Switch on the SD Card] )
0
Is the camera recorder set to the Camera mode?
Press the [CAM/MEDIA] selection button to switch to the Camera
mode.
(A P18 [Operation Modes] )
Camera image is not output on
the LCD monitor and
viewfinder screen.
0
Is the camera recorder set to the Camera mode?
Press the [CAM/MEDIA] selection button to switch to the Camera
mode.
(A P18 [Operation Modes] )
Playback does not start after
selecting a clip thumbnail and
pressing the Set button (R).
0
Is the selected clip a playable clip?
Playback is not possible if the clip has a different video format setting.
206
Error Messages and Actions
Others
To Next Page
Loading...
Need help?
General
