JVC KD-G801 User Manual

13
ENGLISH
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see “Storing
stations in memory” on pages 11 – 13.
1 Select the band (FM1 – 3, AM).
Each time you press the button, the band
changes as follows:
2 Select the number (1 – 6) for the
preset station you want.
Note (only for KD-G701):
You can also use the 5 (up) or ∞ (down) button on
the unit to select the next or previous preset stations.
Each time you press the 5 (up) or ∞ (down) button,
the next or previous preset station is tuned in.
3 Press and hold the number button
(in this example, 1) for more than
2 seconds.
4 Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.
Preset number flashes for a while.
FM 1
(F1)
FM 2
(F2)
FM 3
(F3)
A M
(A1)
(For KD-G801) (For KD-G701)
or
EN10-13_G801_G701[E_EX]f.p65 1/6/04, 12:07 PM13

JVC KD-G801 Specifications