44
ENGLISH
345621
Ex. When you select “Opening”
SEL
ATT
SEL
SEL
3
Select “Opening” (opening screen
setting) or “Ending” (ending screen
setting).
4
Select “User.”
• Default: Factory-preset animation is used.
• User: Your own edited animation is
used.
5
Finish the setting.
To activate the graphic screen using either
picture or movie
Using this setting, you can change the graphic
displays. These graphic screen appears if no
operation is done for about 20 seconds.
• If no image is stored in “Picture,” or no
animation in “Movie,” “UserPict.” will not be
selected as a PSM item.
1
Press and hold SEL (select) for more
than 2 seconds so that one of the
PSM items appears on the display.
(PSM: see pages 47 and 48.)
7 To delete more files, repeat from steps 5 and
6.
8 Press DISP (D) to resume the
source indication screen.
Activating the downloaded
images and animations
To activate the animations stored for
opening and ending screens
After the unit turns on or before the unit turns off,
you can see preset animations on the display.
These are called opening screen and ending
screen. You can use your own edited animations
for these opening and ending screens.
• Opening and ending screens will not be shown
if the “KeyIn CFM” setting is set to “Short" or
“Off.” (See page 48).
• If no animation is stored in “PowerOn” and
“PowerOff,” “Opening” and “Ending” will not be
selected as a PSM item.
1
Press and hold SEL (select) for more
than 2 seconds so that one of the
PSM items appears on the display.
(PSM: see pages 47 and 48.)
2
Press number button 1 to select
“MOVIE”—Movie category of the PSM
settings.
The “Graphics” setting screen appears on
the display.
D
DISP
EN39-45SH9101[E_EX]f.p65 03.2.27, 23:0444
To Next Page
Loading...
Need help?
General
