Remote Controller Remote Controller (Only for KW-V255DBT/KW-V250BT Region 2)
You can use an optionally purchased remote
controller, RM-RK258, for controlling this unit.
• Refer to the instruction manual that comes with the
remote controller.
* DO NOT expose the remote sensor to bright
light (direct sunlight or artificial lighting).
Remote sensor*
Preparation
Removing the battery sheet
Pull the battery sheet out from the remote controller
to activate the battery.
Changing the battery of the remote
controller
CR2025 (+side)
• Use a commercially available button battery
(CR2025).
• Insert the battery with the + and – poles aligned
properly.
– If the effectiveness of the remote controller
decreases, replace the battery.
WARNINGS
• Do not ingest the battery, as it presents a
chemical burn hazard
The remote controller supplied with this product
contains a coin/button cell battery.
If the coin/button cell battery is swallowed, it can
cause severe internal burns in just 2 hours and can
lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely,
stop using the product and keep it away from
children.
If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate
medical attention.
CAUTION
• Do not leave the battery near fire or under direct
sunlight. A fire, explosion or excessive heat
generation may result.
• Do not set the remote controller in hot places such
as on the dashboard.
• Danger of explosion if Lithium battery is incorrectly
replaced. Replace only with the same or equivalent
type.
39
ENGLISH
00_KWV_2019ST_EQ_EN.indb 3900_KWV_2019ST_EQ_EN.indb 39 29/6/2018 11:57:05 AM29/6/2018 11:57:05 AM
To Next Page
Loading...
Need help?
General
