2
Preparation
7
GB
4. To install the base stand, align the screw
holes, then secure with a screw driver (not
included) using the 3 screw B provided.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the TV
slightly overhangs on it. Please make sure a soft cushioned material (such as a pillow or thick piece of foam) is placed beneath
the screen.
Installing the Base Stand
3. To install the TV stand, first attach the stand support to the TV
by using screw A. Align with the screw hole then use screws
to fix the stand support to the TV.
1. To remove the stand assembly, untighten the screws holding the
stand assembly to the rear of the TV. Slide the stand assembly
out.
2. Mounting on the wall. This TV is designed to be wall-mounted
with a standard 100 mm x 100 mm mounting kit (sold
separately) designed for flat-panel TVs. Mount this TV according
to the instructions included in the mounting kit. Due to space
restrictions, we recommend that you make all connections (refer
to page 13-16 and page 48 for details) before mounting on to the
wall.
Installing / Removing the Base Stand
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that
no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert
pressure on the front of the TV at any time because the screen could crack.
Remove the stand assembly before mounting the TV onto the wall.
Keep all the spare screws should you want to use
the stand assembly option.
The screw holes will only align if the
front of the base stand is at the front
of the TV.
• Please read this instruction manual carefully while setting up your TV.
• If you require additional assistance please click on the link for Support Centre:
Norway: www.elkjop.no/service Sweden: www.elgiganten.se/service
Denmark: www.elgiganten.dk/service Finland: www.gigantti.fi/huolto
Screw B x 3
TV Front
Base Stand
Front
screw in
Screw A x 1
screw in
unscrew
Screw A x 1
Mounting the TV to a Wall
100 mm
100 mm
Four mounting holes
(size M4x5 screw)
To Next Page
Loading...
Need help?
General
