34
Using the menu functions
50Signal Quality
Signal : Acceptable
44Signal Strength
Signal Check
D
Service
1 RTL Television
D
2 RTL2
69Channel
69
61
32
22
6
Are you sure you want to delete the PR list and
reset all settings?
The TV will switch off when reset is completed.
Please switch the TV back on.
Yes No
PR Installation menu (continued)
Signal Check
Check the broadcast signal
To check another
broadcast channel
The “Channel” is the frequency of the digital broadcasting. It differs from the
channel number displayed on the TV.
Signal level: Poor < Acceptable < Excellent
Factory Setting
Initialise the settings
Select “Yes” in “Factory Setting” (will enter standby), then turn on from
standby and start the “Initial settings” (P. 13).
2 start
1 select “Yes”
Initial setting will start again.
“Initial settings” (P. 13)
Auto Demonstration
Demonstration and slide show of this TV’s
function
On
Set to automatically start the demonstration
Off
Function is turned off
Retuning menu
You can set the TV to restart the initial setting. For details refer to step 2 in
“Initial setting” (P. 13)
Make sure the “Auto Demonstration” is set to “Off”, when using “Photo
Viewer”, “Retuning”, “Auto Scan” , “Manual Scan”, or “Update Scan”.
When Timer (P. 21) is set, Auto Demonstration can not be selected.
Do not connect USB device when “Auto Demonstration” is set to “On”.
When set to “On”, it automatically enters demonstration every time
no operation is made for approximately 3 minutes. To stop automatic
demonstration, set “Auto Demonstration” to “Off”.
For details of “100Hz Clear Motion Drive II” demonstration, refer to page 41.
2 set
1 select
To Next Page
Loading...
Need help?
General
