15
Basic iPod Operations
NOTES
• The iPod battery is charged while the System is turned on or on standby (except in ECO mode).
See the iPod instruction manual about battery charging.
• If you connect an iPod to the iPod terminal and a USB mass storage class device to the USB
MEMORY terminal at the same time, the System might be overloaded.
• Sound distortion may occur when playing back audio sources with high recording levels. When
distortion occurs, it is recommended to turn off the equalizer of the iPod. For information on
operating the iPod, see the iPod instruction manual.
• JVC is not responsible for any loss of or damage to iPod that might result from the use of this
product.
• When you connect your iPod to the docking station, make sure the connector on the docking
station is fully inserted into the iPod.
• Do not carry the System with iPod connected. You might drop it down or it might cause damages
to the connector part.
• Do not touch or hit the terminals of the docking station and of the iPod. It might cause damages to
these terminals.
• Remove the iPod from the docking station when you do not use it.
• Always set volume to the minimum level when connecting or disconnecting the iPod.
Button
Function
On the Unit On the remote
Starts playback / Pauses
Press and hold: The iPod is in sleep mode
Increases the track numbers.
Press and hold: Fast forward search
Decreases the track numbers.
Press and hold: Fast reverse search
(Press this button during playback to jump back to the beginning of the
track.)
NX-PS2[A].BOOK Page 15 Friday, April 20, 2007 8:36 PM
To Next Page
Loading...
Need help?
General
