19
Listening to FM Broadcast
Basic Operations
To select FM for the source
Basic Tuner Operations
Presetting Stations
You can preset 30 FM stations.
NOTE
• When you unplug the AC power cord or if a power failure occurs, the preset stations will be erased
in two days.
Select FM for the source.
• FM can also be selected by the FUNCTION button on the main unit.
• If an FM programme is broadcast in stereo, ST (stereo) appears on the display (only when the
reception is good).
Buttons
Functions
On the Unit On the remote
Changes the frequencies
Press and hold: The System starts searching for stations and stops
when tuning in to a station of sufficient signal strength.
• To stop searching, press again.
Tunes in to a preset station: Press repeatedly to select a preset station
number. (For presetting stations, see “Presetting Stations” below.)
Changes the FM reception mode: When an FM stereo broadcast is hard
to receive or noisy, press to improve reception. MONO (monaural)
appears on the display. Reception will improve though the stereo effect
is lost.
• To restore the stereo effect, press again.
1
Tune in to a station you want to preset.
• You can also store the monaural reception mode for FM preset stations if selected.
2
Press to activate the preset number entry mode.
• Finish the following operations while the indication on the display is flashing.
3
Press repeatedly to select a preset number for the station you want to store.
4
Press to store the station.
FM
AUX
or
or
—
or
—
or
or
NX-PS2[A].BOOK Page 19 Friday, April 20, 2007 8:36 PM
To Next Page
Loading...
Need help?
General
