1-8 (No.YD125<Rev.001>)
(2) When disc reading is completed, the following displays are repeated in the display window on the main unit. “APPLI FIRM” →
“START [PLAY]” → “CANCEL [FF]”. Press the [PLAY] button on the main unit to start update.
When update starts, the followings are displayed in the display window on the main unit.
“L 10” → “L 20” → *** → “L 100” →
“C 10” → *** → *** → “C 100” → “W 10” → *** → “W 100”
“R 10” → *** → “R 100” → “V 00” → “COMPLETED”
(3) After update disc reading, the tray is ejected. Remove the update disc.
(4) Press the POWER button on the main unit.
The main unit power is turned on, and then turned off. The update is completed.
(5) In the TEST MODE menu, check whether the main unit firmware is correctly updated.
5.3 UPDATING SYSCON FIRMWARE
• The SYSCON firmware update disc supports CD-R.
• When SYSCON firmware update is needed, information will be available from SMIS in JS-NET.
5.3.1 Creating an Update Disc
Refer to JS-NET for details of creating an update disc.
(1) Download the update file (#########.iso) from SMIS in JS-NET.
(2) Write the update file onto a CD-R in image writing using writing software.
• Be sure to write in “Disc-at-Once”.
• Refer to the instructions of the writing software for image writing settings.
5.3.2 Update Procedures
(1) Place an update disc on the tray and close the tray.
During disc reading, a warning “THERE IS NO PLAYABLE MEDIA INSERTED” is displayed once or twice. Ignore the warning.
(2) When disc reading is completed, the following displays are repeated in the display window on the main unit. “SYSCON FIRM”
→ “START [PLAY]” → “CANCEL [FF]”.
Press the [PLAY] button on the main unit to start update.
When update starts, “PLEASE WAIT” is displayed in the display window on the main unit.
(3) After update disc reading, the following is displayed on the TV screen and the tray is ejected. Remove the update disc.
(4) Press the POWER button on the main unit.
The main unit power is turned off and update is completed.
(5) In the TEST MODE menu, check whether the SYSCON firmware is correctly updated.
5.4 UPDATING DRIVE FIRMWARE
• The drive firmware update disc supports CD-R.
• When drive firmware update is needed, information will be available from SMIS in JS-NET.
5.4.1 Creating an Update Disc
Refer to JS-NET for details of creating an update disc.
(1) Download the update file (#########.iso) from SMIS in JS-NET.
(2) Write the update file onto a CD-R in image writing using writing software.
• Be sure to write in “Disc-at-Once”.
• Refer to the instructions of the writing software for image writing settings.
CONFIRM
THERE IS NO PLAYABLE MEDIA INSERTED
SYSCON FIRM UPDATE COMPLETE!!
Take out the disc and turn off power.
To Next Page
Loading...
Need help?
General
