(No.YD125<Rev.001>)1-9
5.4.2 Update Procedures
(1) Place an update disc on the tray and close the tray.
During disc reading, a warning “THERE IS NO PLAYABLE MEDIA INSERTED” is displayed once or twice. Ignore the warning.
(2) When disc reading is completed, the following displays are repeated in the display window on the main unit. “DRIVE FIRM” →
“START [PLAY]” → “CANCEL [FF]”. Press the [PLAY] button on the main unit to start update.
When update starts, “PLEASE WAIT” is displayed in the display window on the main unit.
(3) After update disc reading, the following is displayed on the TV screen and the tray is ejected. Remove the update disc.
(4) Press the POWER button on the main unit.
The main unit power is turned off and update is completed.
(5) In the TEST MODE menu, check whether the drive firmware is correctly updated.
5.5 INITIALIZING TO FACTORY SETTING
Before starting initialization, always obtain permission from the user as initialization returns all the setting information to the initial set-
tings, and the user content and the related information will all be erased.
(1) Set the main unit to the TEST MODE.
(2) Transmit “##
·6F” using the JIG remote control. (Set “##” as follows according to the main unit remote control code. Code setting
1: Set “##” to “43”. Code setting 2: Set “##” to “53”. Code setting 3: Set “##” to “6F”. Code setting 4: Set ““##” to “7F”).
“COLD SET” flashes in the display window on the main unit. The initialization completes in about 30 seconds and the power is
turned off.
CONFIRM
THERE IS NO PLAYABLE MEDIA INSERTED
DRIVE FIRM UPDATE COMPLETE!!
Take out the disc and turn off power.
Custom code
43:A(1) Code
53:B(2) Code
6F:C(3) Code
7F:D(4) Code
Data code
Initial
mode
JIG remote control
3
JIG remote control
[Data transmission]
Set the data code,
and then press the
" " button.
(Part number : PTU94023B)
To Next Page
Loading...
Need help?
General
