11
Wall Mounting
• Installation must be carried out by qualied personnel only. Incorrect assembly can result in severe
personal injury and property damage (if you intend to install this product yourself, you must check
for installations such as electrical wiring and plumbing that may be buried inside the wall). It is the
installer’s responsibility to verify that the wall will safely support the total load of the soundbar.
• Additional tools (not included) are required for the installation.
• Do not overtighten screws.
• Keep this instruction manual for future reference.
• Use an electronic stud nder to check the wall type before drilling and mounting.
1. Drill 4 parallel holes (Ø 3-8 mm each according to wall type) in the wall. The distance
between the holes should be 380 mm.
3. Tighten the wall mount brackets on the wall with screws (included) and screwdriver
(not included). Make sure that they are securely installed.
Dowel
Solid wall (i.e., Solid brick,
Solid concrete, Solid wood,
Solid wooden battens)
Drywall, Plaster wall,
Lath wall, etc.
2. Firmly x 1 dowel (included) into each hole in the wall if necessary.
380 mm
TH-D227B_IB_FInal171017V3.indd 11 17/10/2017 4:37 PM
To Next Page
Loading...
Need help?
General
