Troubleshooting
In the event of malfunctions, please check the following points:
No sound
Insert the mains plug in properly.
Adjust the volume to the correct level.
Make sure that the correct source is selected.
Left and right channel mixed up
Check the speaker connection and their locations.
The system is not responding to button pressing
Removethemainsplugandconnectitagain.
Problems with radio reception
Readjusttheantenna.
Look for a more suitable location.
If possible use an outdoor antenna.
Other electrical devices are disturbing the reception.
Location not suitable for DAB+ reception.
CD-Player – display “NO DISC”
Insert the CD with the labelled side facing up.
Clean the CD.
Use only compliant CDs.
USB operation
“NO USB“ Turn the device off and then re-connect the USB device.
“NO SONG” PleasemakesurethattheUSBdevicecontainscompatibleles.
Remote control - not working properly
Change the battery.
Removeanyobstructions
Move closer to the main device and make sure that you are pointing towards the remote control
sensor on the device.
Maintenance and care
Cleaning the housing: Use a cloth which is slightly dampened with a mild cleanser. Do not use any
cleanser which contains alcohol, ammonia or abrasives.
Cleaning CDs
• Clean soiled discs with a special cleaning cloth. Wipe the disc in straight lines
from the middle to the edge. Do not wipe with a circular motion.
• Do not use any solution, such as white spirit, thinner, commercial detergents
or anti-static spray for analogue records.
Precautions regarding condensation formation
Condensationcanforminsidethedevicewhenthereisasignicantdifferencebetweenthetempera-
ture of the device and the ambient temperature. If condensation should develop in the device interior,
proper function can no longer be ensured. In this case, it is imperative to wait for several hours after
the dampness has dried before the device can be used again.
Particular care must be taken in the following circumstances
Ifthedeviceismovedfromonelocationtoanotherlocationwhichissignicantlyhotterorcolderor
if the humidity has increased in the installation location of the device etc.
17