To Next Page

To Previous Page

• If no button is pressed in approximately 60 seconds, the unit exits clock setting mode automatically.

• If DISC / USB source is selected and the audio cannot be played, TUNER is activated automatically.

• If timer is activated, the blue indicator will light up.

Daily Timer

You can use the setting timer to make the unit automatically turn on at a certain time every

day from standby. The clock must be correctly set for the timer to operate correctly.

1. In Standby mode, press the CLOCK button to show the clock time on the display. Press

and hold TIMER/SLEEP until “TIMER SET“ scrolls across the display. Then the hour

indicator will blink.

2. Press / on the remote control to set the hour, then press the TIMER/SLEEP button

to conrm. The minute indicator will blink.

3. Press / on the remote control to set the minute, then press the TIMER/SLEEP

button to conrm. The mode will then blink on the display.

4. Press / on the remote control to set the mode.

a) DISC – sets alarm to wake to your DISC music.

b) FM – sets alarm to wake to select FM Radio Station.

c) DAB – sets alarm to wake to select DAB Radio Station.

d) USB – sets alarm to wake to USB music.

5. Press the TIMER/SLEEP button to conrm, then use / to adjust the alarm volume.

6. Press TIMER/SLEEP to conrm. The display will show “TMR ON / TMR OFF”.

7. Press / to select TMR ON or TMR OFF and press TIMER/SLEEP to conrm.

To Deactivate or Re-activate a Daily Timer

In Standby mode, repeatedly press TIMER/SLEEP on the remote control to activate or

deactivate the timer.

DAB Radio Operation

Press the SOURCE button on the unit or press the DAB button on the remote control to

select DAB source. The word “DAB” will be showed on the display.

1. If the unit is connected to the mains power and then switched on to DAB mode for the

rst time, the unit will automatically start scanning. The display will show “SCANNING”.

2. All the stations that have been found will be stored automatically. To explore the found

stations, press / buttons on the remote control.

3. To re-tune, press the INTRO/SCAN button on the remote control to perform a quick

scan again.

UX-D427S_IB_FInal180625V3.indd 18 26/6/2018 5:30 PM

JVC UX-D427S User Manual

Questions and Answers: