19
Auto Scan
The auto scan will search for the entire DAB Band III channels. After the scan has nished,
the rst alphanumerically found station will be automatically selected.
1. Press the INTRO/SCAN button on the remote control to activate automatic program
mode. The display will show “SCANNING” to indicate the progress of the scan and the
number of stations found so far.
2. Once the scan has nished, the unit will display the total number of stations that have
been found and a list of the found stations. All stations that have been found will be
automatically stored.
You may press and hold / CLEAR button to clear the previously tuned stations before running an auto
scan. The display will show CLEAR. All the tuned stations in both DAB and FM will be cleared.
Manual Tuning
As well as the auto tune function, you can also manually tune the receiver. This can help you
when aligning your aerial or when adding stations that were missed while auto tuning.
1. Press and hold the / PAIR button to select Manual tune, the display will now show
“MANUAL TUNE”.
2. Press / to cycle through the DAB channels in the frequency range of 174.928MHz
to 239.200MHz.
3. After your desired channel number is selected, press the ENTER button to conrm,
display will now show “TUNING”. The unit will start to scan.
Secondary Services
You may see a “>>” symbol after the name of the station, this indicates that there are
secondary services available to that station. These secondary services contain extra
services that are related to the primary station. e.g. a sports station may want to add extra
commentaries. The secondary services are inserted directly after the primary station in the
station list.
To select the secondary station, press / until you nd the secondary service you
want.
When the secondary service ends, the unit will automatically switch back to the primary
station.
Presetting Stations
You can store up to 20 of your favourite stations to the memory. This will enable you to
access your favourite stations quickly and easily.
1. To store a preset, you must rst be listening to the station that you would like to save.
2. Press the PROG button to activate program mode. The preset number will blink in the
display.
3. Press ALBUM/PRESET / to select the desired station preset number.
4. Press the PROG button again to store the station, the display will show “SAVED”.
Recalling a Preset Station
Once you have saved a station, you can recall a preset station by pressing ALBUM/PRESET
/ . The band and frequency will be shown on the display, press ENTER to conrm.
UX-D427S_IB_FInal180625V3.indd 19 26/6/2018 5:30 PM
To Next Page
Loading...
Need help?
General
