8
Listening to the Radio
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Station searching starts and frequency indication starts
changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the searching will stop.
To stop searching manually,
press either button.
• When you repeatedly press the button, the frequency
changes step by step.
If the received FM station is hard to listen
Reception will improve though stereo effect is lost. MONO
indicator lights up.
To restore the stereo effect,
press FM/AM repeatedly to
select FM.
To preset the stations
You can preset 20 FM and 10 AM stations.
1 Tune in to a station you want to preset.
2 Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing.
3 Select a preset number for the station you want to
store.
4 Store the station.
To tune in to a preset station
1 Select a band (FM or AM).
2 Select a number of the preset station you stored.
The PROG indicator lights up on the display.
FM/AM
FM FM MONO
AM
TUNING/GROUP/PTY
1 sec.
FM/AM
FM FM MONO
AM
To select a number, see “How to
select numbers” on page 7.
• You can also use the
PRESET
1 or PRESET y
button.
To select a number, see “How to
select numbers” on page 7.
• You can also use the
PRESET
1 or PRESET y
button.
MHz
kHz
DISPLAY/
PROGRAM
"
%
#
&
!
$
'
DISPLAY/
PROGRAM
FM/AM
FM FM MONO
AM
"
%
#
&
!
$
'
UX-G100[B].BOOK Page 8 Monday, June 30, 2008 6:31 PM
To Next Page
Loading...
Need help?
General
