25
Handling cassette tapes
• If the tape is loose in its cassette, take up the slack by inserting
a pencil in one of the reels and rotate it.
– If the tape is loose, it may get stretched, cut, or caught in the
cassette.
• Be careful not to touch the tape surface.
• Avoid the following places to store the tape—in dusty places,
in direct sunlight or heat, in moist areas, on a TV or speaker,
or near a magnet.
To keep the best recording and playback sound quality
• Use a cotton swab moistened with alcohol to clean the heads,
capstans, and pinch rollers.
• Use a head demagnetizer (available at electronics and audio
shops) to demagnetize the heads (when the System turned off).
Cleaning the System
• Stains should be wiped off with a soft cloth. If the System is
heavily stained, wipe it with a cloth soaked in water-diluted
neutral detergent and wrung well, then wipe clean with a dry
cloth.
• Since the System may deteriorate in quality, it become
damaged or get its paint peeled off, be careful about the
following:
– DO NOT wipe it with a hard cloth.
– DO NOT wipe it strongly.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substance such as insecticides
to it.
– DO NOT allow any rubber or plastic to remain in contact for
a long time.
Specifications
Amplifier section
Output Power: 7 W per channel, min. RMS,
driven into 4 Ω at 1 kHz with no
more than 10% total harmonic
distortion. (IEC268-3)
Speakers/Impedance: 4 Ω – 8 Ω
Tuner section
FM tuning range: 87.50 MHz – 108.00 MHz
AM (MW) tuning range: 522 kHz – 1 629 kHz
CD player section
Dynamic range: 60 dB
Signal-to-noise ratio: 60 dB
Wow and flutter: Immeasurable
Cassette deck section
Frequency response
Normal (type I): 125 Hz – 8 kHz
Wow and flutter: 0.35% (WRMS)
General
Power requirement: AC 230 V , 50 Hz
Power consumption: 26 W (at operation)
1 W (on standby)
Dimensions (approx.): 140 mm × 209 mm × 208 mm
(W/H/D)
Mass (approx.): 2.52 kg
Speakers
Type: 1-way Bass reflex
Speaker units: 10 cm cone × 1
Impedance: 4 Ω
Dimensions (approx.): 135 mm × 209 mm × 175 mm
(W/H/D)
Mass (approx.): 1.16 kg each
Supplied Accessories
See page 3.
Design and specifications are subject to change without notice.
To protect your recording
Cassettes have two small tabs to protect from unexpected
erasure or re-recording.
To protect your recording, remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
UX-G100[B].BOOK Page 25 Monday, June 30, 2008 6:31 PM
To Next Page
Loading...
Need help?
General
