Kärcher NT 30/1 Ap L User Manual

– 3
– Please follow the safety regulations ap-
plicable to the materials that are to be
treated.
– Press the parking brake to the steering
roller for a secure footing. The device
may move uncontrollably if the parking
brake is open.
몇 WARNING
The flat pleated filter must always be in
place while vacuuming.
몇 WARNING
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
Only for appliances with built-in socket:
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.
– NT 30/1: The device is equipped with a
fleece filter bag with a lock cap, order
no. 2.889-154.0 (5 units).
– NT 40/1, NT 50/1: The device is
equipped with a fleece filter bag with a
lock cap, order no. 2.889-155.0 (5 units).
Note: You can use this appliance to vacu-
um all types of dust up to dust class L.
Note: The appliance is suited as industrial
vacuum cleaner to take up dry, non-com-
bustible dusts with AGW values greater
than or equal to 1 mg/m
3
.
– When vacuuming fine dust, a fleece fil-
ter or dust bag (option) can also be
used.
Illustration
 Release and remove the suction head.
 Insert the fleece filter bag.
 Insert and lock the suction head.
Illustration
 Release and remove the suction head.
 Insert the disposal bag (option).
 Pull disposal bag (option) over the con-
tainer.
Make sure that the marking line is situ-
ated within the container and both ven-
tilation holes are positioned at the back
of the container.
 Insert and lock the suction head.
Applicable only for flat fold filter (Cellulose):
ATTENTION
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter ele-
ment is still wet the filter will become ob-
structed and may be damaged beyond re-
pair.
 Replace wet filter with a dry one prior to
use.
 Change the filter according to instruc-
tions under the section "Maintenance
and Care".
Note: For permanent wet vacuum cleaning
it is advisable to use a PES flat pleated filter
(see filter systems).
 DANGER
No dusts hazardous to health should be
sucked in during wet vacuuming.
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Illustration
 Release and remove the suction head.
 Pull out the fleece filter bag on the
flange towards the top.
 Tightly close the fleece filter bag with
lock cap.
Start up
Anti-static system
Dry vacuum cleaning
Install fleece filter bag
Installing the dust disposal bag
Changeover from wet to dry vacuum
cleaning
Wet vacuum cleaning
Inserting the rubber lips
Remove the fleece filter bag
18 EN

Kärcher NT 30/1 Ap L Specifications

General

Airflow	74 l/s
Proper use	Professional
Noise level	70 dB
Removable filter	Yes
Cleaning surfaces	Hard floor
Vacuum air filtering	-
Dirt separating method	Filtering
Cord length	7.5 m
Type	Drum vacuum
Hose length	2.5 m
Cleaning type	Dry&wet
Dust capacity	30 L
Hose diameter	35 mm
Product color	Black, Grey, Yellow
Dust container type	Bagless
International Protection (IP) code	IPX4
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Maximum input power	1380 W
Annual energy consumption	- kWh

Weight and Dimensions

Depth	525 mm
Width	370 mm
Height	560 mm
Weight	11800 g