27
GB
Installation and Connection
1.1.2Connection of the
Control
In order to prevent a malfunction caused by interference voltage supply
on the control inputs, the following directions should be observed:
- Use shielded/drilled cables
- Lay shield on one side of the inverter onto earth potential
- Lay control and power cable separately (about 10...20 cm apart)
- Lay crossings in a right angle (in case it cannot be prevented)
1.1.4 Analog Inputs
1.1.3 Digital Inputs
13...30VDC
set-point setting
0...±10 DCV
Ri= 40 kΩ
4567 1011 1314 1920
PE
4567 1011 1314 1920
+
PE
EMC
Use of external voltage supply
Use of internal voltage supply
16 17 18 PE
+
+
R= 3...10 kΩ
0...10 VDC
Ri = 56 kΩ
0(4)...20 mADC
Ri = 250 Ω
Analog set-point
setting (see CP.24)
In order to prevent undefined
conditions during external
power supply, the external
power supply should be
switched on first and then the
inverter.
When using inductive
consumers at the relay output a
protective wiring (i.e. free
wheeling diode) is necessary to
protect the relay!
Connect unused analog
inputs to common, to prevent
set value fluctuations!
89 18
+-
SPS
PE
13...30V DC
±0%smoothed
Ri =4,4 kΩ
Analog output:
0...10VDC / max. 5mA
Ri < 100 Ω
ext. voltage supply
16...30VDC
1.1.5Outputs
1 2 3 12 21 22 231413
+15V
15 18
+
PE
+
250V AC / 0,2 mA
30V DC / 1 A
250V AC / 0,2 mA
30V DC / 1 A
30V DC/0,01...1A
30V DC/0,01...1A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General