1 Introduction
1.1 Purpose of the document
This document describes the structure of the CP 263/x (CPU module).
Additionally, the installation and configuration is described enough to obtain
an operationally ready module. "Ready for operation" means that the assembly
is ready for the synchronization of the firmware and the application.
Information
This manual is not addressed to end customers! Necessary safety notes for
the end customer have to be taken into the customer manual in the respective
national language by the machine builders and system providers.
1.2 Preconditions
This document contains information for persons with the following skills:
Target group Knowledge and skills pre-requirement
Project engineer
Basic technical training (University of Applied Science/University level,
engineering degree or corresponding professional experience).
Knowledge in:
● working mode of a PLC,
● current valid safety regulations,
● the application.
Electrician
Specialized training in the electro-technical field (in accordance with
industrial training guidelines).
Knowledge in:
● current valid safety regulations,
● wiring guidelines,
● circuit diagrams,
● correct installation of electrical connections according to national
and international regulations.
CP 263/S, CP 263/X Introduction
© KEBA 2014
Project engineering manual V1.01 9
To Next Page
Loading...
Need help?
General
