2-4 Return to Section Topics 2600AS-900-01 Rev. B / September 2008
Section 2: Remote Operation Series 2600A System SourceMeter® Instruments User’s Manual
CAUTION The ipconfig/all command displays the configuration of all network
connections. Be sure to record the information for the proper network card.
Figure 2-3
Computer configuration using the command prompt
3. Verify DHCP or Static IP status.
• To determine the next step, check the DHCP Enabled setting in the IP configuration
screen or in the settings recorded earlier.
a. If DHCP Enabled = Yes, proceed to Step 2: Disable DHCP to use the computer's
existing IP address.
b. If DHCP Enabled = No, proceed to Step 3: Configure the Instrument's LAN settings.
NOTE When DHCP Enabled = Yes, the settings are assigned automatically
upon power up. However, if DHCP Enabled = No, the network will not
recognize the PC if the original settings are changed. If at any time
you are unsure how to proceed, contact your system administrator.
4. To exit the IP configuration screen, type exit at the command prompt and press ENTER.
To Next Page
Loading...
Need help?
General
