PERFORMANCE FEATURES
, WARNING
Personal injury Hazard
Always turn off and unplug the vacuum
cleaner before cleaning the agitator area
as agitator may suddenly restart. Failure
to do so can result in personal injury.
OVERLOAD PROTECTOR
The PowerMate®
has built-in
protection against
motor and belt
damage should the
agitator jam. if the
agitator slows down
or stops,the
Overload Protector/
Beff Reset Button
overload protector shuts off the
PowerMate ®. The canister motor will
continue to run.
To correct problem: Turn off and unplug
vacuum cleaner, remove obstruction, then
press BELT RESET button.
If the problem persists, have the vacuum
cleaner serviced by a Sears or other
qualified service agent.
EDGE CLEANER
Active brush edge
cleaners are on both
sides of the PowerMate ®.
Guide either side of the
PowerMate ® along
base-boards or next to
furniture to help remove
dirt trapped at carpet
edges.
SUCTION CONTROL
The suction
control allows
you to change
the vacuum
suction for Suction
different fabrics
and carpet weights. Opening the control
decreases suction for draperies and
lightweight rugs, while closing the control
increases suction for upholsteries and
carpets.
Suction
THERMAL PROTECTOR
This vacuum cleaner has a thermal
protector which automatically trips to
protect the vacuum cleaner from
overheating. If a clog or a full dust bag
prevents the normal flow of air to the
motor, the thermal protector turns the
motor off automatically. This allows the
motor to coot in order to prevent possible
damage to the vacuum cleaner.
To correct problem: Turn the vacuum
cleaner off and unplug the power cord
from the outlet to allow the vacuum
cleaner to cool and the thermal protector
to reset. Check for and remove clogs or
replace the dust bag, if necessary. Also
check and replace any clogged filters.
Wait approximately thirty (30) minutes
and plug the vacuum cleaner in and turn
back on to see if the motor protector has
reset.
= 13 =
To Next Page
Loading...
Need help?
General
