WATER SOFTENER START-UP
SECTION 1
5
1B. CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL
To be sure you have done all the steps to install the
softener, readthe followinglist. Refer to theInstalla-
tion Manual, part no. 7183613, for step-by-step
guides.
Page numbers referred to are in the Installation
Manual unless otherwise noted.
4 Is the house water flow goingINTO the softener
valve INLET? Trace piping to be sure. See pages
10 and 11.
4 Is theplumbingbypass valve(or3valves) setfor
SERVICE?Bypassvalve(s)shouldalwaysremain
in soft water service position. Position in “by-
pass”onlyifneededforsoftenerrepairs.SeeFIG.
12, page 20 of this manual.
4 Is the valve drain hose connected the right way,
andwithoutsharpbends orkinksthatcouldstop
or reduce water flow? See page 16.
Page numbers referred to are in the Installation
Manual unless otherwise noted.
4 Is the softener power cable connected to the
transformer? Is the transformer plugged into an
inside, 120V-60Hz electrical outlet? See page 20
in the installation manual, and the wiring sche-
matic on page 21 of this manual.
4 Be sure to restart the water heater. See page 20.
VALVE
INLET
plastic
3--valve
Bypass Valve(s)
To Next Page
Loading...
Need help?
General
