REMOVE •
Starting and Stopping Compactor
Drawer must be at least 1/3 full before compactor will compact trash.
To start your compactor:
Turn Key-Knob to "START" Q and
release.
The compactor will stop automatically
when cycle is done.
You can stop compactor anytime
during the cycle:
1. Turn Key-Knob to off position Q.
2. Turn Key-Knob to "START" (_.
The ram inside the compactor will
rise to the top position.
3. Open drawer and adjust trash or
add trash.
If you will be away for more than a
couple of days, remove compactor
bag. Remove Key-Knob and store it
in a safe place.
How your compactor works
A ram inside the top of the compactor
uses pressure to force trash down to
bottom of drawer. The ram will go
down and back up. The compactor
then automatically shuts off.
The drawer has to be about 1/3 full
before any trash will be compacted
O because the ram does not go to
bottom of drawer.
When trash is compacted, it will
become about 1/4 of its original
size _).
You will hear noise when containers
break. Strong glass bottles may
not ever break.
There are two drawer monitor
switches, one on the front of
compactor opening and one on the
inside rear wall behind drawer. Both
switches must be engaged before
ram will compact trash. The drawer
must be completely closed to activate
switches. If compactor stops during
the cycle, the drawer has opened
during compacting. To complete
the cycle you will need to close
the drawer completely and turn
Key-Knob to "START".
NORMAL EXTRA
PAC PAC
NORMAL EXTRA
PAC PAC
EXTRA PACTM Cycle
The EXTRA PAC feature helps you
to use fewer bags or to extend the
use of a bag until trash pickup day.
During EXTRA PAC Cycle the ram
stays in the down position and
continues to apply pressure to trash.
This keeps trash from springing
back. Using EXTRA PAC Cycle
will increase bag capacity by 25%.
1. Push cycle control to
"EXTRA PAC" O.
2. Turn Key-Knob to "START" _) and
release (_. The EXTRA PAC light
will go on. The ram will stay in the
down position and drawer cannot
be opened. For best results use
EXTRA PAC Cycle for at least
a half hour or overnight.
3. To end EXTRA PAC cycle, tum Key-
Knob to "START" (_) and release _).
Or push Cycle Control to "NORMAL
PAC" _). The ram will retum to the top
position and EXTRA PAC light will go out.
Remember, using this cycle puts
more trash into bag and it will be
heavier than normal. Special care
will be needed when you remove
the bag,
To Next Page
Loading...
Need help?
General
