3-prong
grounding-type
wall receptacle _ J=_,
, _PqL J
3-prong
grounding i _._
Plug ......_.._
grounding
prong
power
supply cord
Electrical requirements
Electrical Shock Hazard
Plug into a grounded 3-prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
Recommended grounding method
For your personal safety, compactor
must be grounded. This compactor
is equipped with a power supply cord
having a 3-prong grounding plug. To
minimize possible shock hazard, the
cord must be plugged into mating,
3-prong, grounding-type wall
receptacle, grounded in accordance
If codes permit and a separate
grounding wire is used, it is
recommended that a qualified
electrician determine that the
grounding path is adequate.
Important: Observe all governing
codes and ordinances.
Do not modify power supply cord
plug.
Do not have a fuse in the neutral
or grounding circuit.
You must have:
• 120-volt, 60-Hz, AC-only, 15- or
20-amp., fused electrical supply.
We recommend:
• a time-delay fuse or circuit breaker.
• a separate circuit.
with all national and local codes and
ordinances. If a mating wall
receptacle is not available, it is the
personal responsibility and obligation
of the customer to have a properly
grounded, 3-prong, wall receptacle
installed by a qualified electrician.
Installing compactor
Do not grasp console to move
compactor.
Slide compactor onto cardboard
or hardboard before moving
compactor across floor to prevent
damaging floor covering.
Do not allow the rear frame of
the compactor to touch the floor
covering when lifting or moving
compactor.
Excessive Weight Hazard
Use two or more people to
move and install compactor.
Failure to do so can result in
back or other injury.
= Remove all protective
packaging materials such as tape
and shipping pads. Remove waxy
residue caused by protective shipping
material with a mild solution of
dishwashing liquid and water.
To Next Page
Loading...
Need help?
General
