Kenwood 1060VR User Manual

4070VR/1080VR (En/K)
Preparations ¢Turn on the power to the related compo-
nents.
mponent
RAE
ROS
EEE
Ss
ES
eS
aE
a
wa
ON/STANDBY
AON : Sound from the speakers connected to the SPEAK-
ERS A terminals on the rear panel.
BON _ : Sound from the sneakers connected ta the SPFAK-
ERS B terminals on the rear panel.
A+BON :Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers [Ise this setting when
listening with headphones for stereo sound in all
playback modes.
¢ When both SPEAKERS A and B are ON activating a surround made
turns SPEAKERS B OFF automatically.
The indicator for the speakers you want to use should be lit.
Soloct the source you desire.
The input sources change as shown below:
@ TUNER (Frequency display)
@ “PHONO™(“PHONO"*)
@ “VIDEO1" ("SAT"*)
® "VIDEO2" ("LD"*)
& “VIDEO3" ("VCR™*)
@® “AV AUX"
@ "CD" ("CD"*)
@ “TAPE/MD" {("TAPE”*)
INPUT SELECTOR
Start
playback
from
the
selected
source.
*
Once
setup
Codes
are
registered
In
Ine
remote
control,
tne
input
name
display changes according to the name of the registered component.
Example: if you register a VCR at the VIDEO 1 jacks, "VCR1" appears
5 | Adjust the volume. instead of "VIDEO 1". -S
* When using the remote control after initial setup, any inputs that have
ee
not
been
registered
with
a
setup
code
are
deleted
from
the
cyclic
list
{except
for
the
“AV
AUX" VIDEO
input).
*
The
INPUT
SELECTOR
on the
front
panel of
the
receiver
always
cycles
through
ali
inputs.
Own’
uP
Decrease volume Increase volume
Volume display

Kenwood 1060VR Specifications

General

Brand	Kenwood
Model	1060VR
Category	Stereo Receiver
Language	English