Kenwood 1060VR User Manual

1070VR/1060VR (En/K]
Make connections as shown below.
De not connoot the power cord to a wall outlet until all conncetions are completed.
Antenna terminal connections
@ Puch laver @ Insert cord
© Return lever
er TRE CN TET a i i a
AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as
possible from the receiver, TV set, speaker cords and power
cord, and adjust the direction for best reception
FM indoor antenna
Use an optional antenna adaptor
FM outdoor antenna
FM indoor antenna FM outdoor antenna
The supplied indoor antenna is for temporary use only. For stable Lead the 75Q coaxial cable connected to the FM outdoor antenna
signal reception we recommend using an outdoor antenna. into the room and connect it to the FM 75Q terminal.
Disconnect the indoor antenna when you connect one outdoors.
FM DE-EMPHASIS / CHANNEL SPACE (Except for USA. and Canada)
The FM DE-EMPHASIS / CHANNEL SPACE switch on the rear Xs
panelis set to the correct setting that prevails in the area to which
the unit is shipped. However, if the FM DE-EMPHASIS / CHAN-
NEL SPACE setting is not matched to the area where the unit is
to be used; for instance, when you move from area 1 to area 2 or
———
deollo,
vice versa, desired reception of AM / FM broadcasts is not a ‘ a a
expected. In this case, change the FM DE-EMPHASIS / CHAN- 2oig A [a2 tone 200s
NEL SPACE setting in accordance with the area corresponding to
the table. The FM DE-EMPHASIS is switched over at the same
time.
| Area CHANNEL FM
When changing the setting of the FM DE-EMPHASIS / CHANNEL SPACE freq. |DE-EMPHASIS
SPACE switch, first disconnect the power cord, then reset the channel U.S.A.. Canada and FM: 100 kHz
space switch, connect the power cord again, and turn the power on. 1 Sauth ‘arhatinan neainttle AM: 10kHz 75 us
2 Other countries Ae 4 ie 50 ps
L

Kenwood 1060VR Specifications

General

Brand	Kenwood
Model	1060VR
Category	Stereo Receiver
Language	English