Kenwood 1060VR User Manual

1D70VR/1080VR [En/K}
GAH Keys or controls used In tnis operation.
Operating other components
This operation lets you operate the registered components.
KENWOOD audio components with system control turn on and off automatically with the receiver via the system control
connections.
@ Use the VIDEO, AUDIO, or TV keys to
select the component you desire.
AUDI
@ Press the SHIFT key and then press the
POWER key (within 3 seconds).
‘SHIFT
Bed mp ER vo
ss cA
© Press the operation keys you desire.
a Re
-HU
¢ Pressing the VIDEO or AUDIO key also changes the input selector on
the receiver. If you do not want to change the current input, press the
SHIFT key before step @. -2g
VIDEO key AUDIO key TV key
@ VIDEO1 (VCR 1) @ CD (CD) Q Tv1
@ VIDEO2 (VCR 2) @ TAPE/MD @ Tv2
@ VIDEO3 {LD} (TAPE) @ CABLE
@ AV AUX @ TUNER
@ PHONO
* Pressing the SHIFT key is only required when turning the selected
component on or off. Pressing the POWER key directy turns the
receiver on and off.
¢ See "Remote operation of other components" at the end of this manual
for a lit of keye available with cach compenont. (a2)
The remote contro! mode remains in the set at the compo-
nent selected in step @ mode until you select another
eamponent late )
Be sure to point the remote control at the remote sensor on the receiver when you want to operate KENWOOD components connected by
Noe oyotem control cords. Otherwise, point the remote contrel at the component you went to operate.

Kenwood 1060VR Specifications

General

Brand	Kenwood
Model	1060VR
Category	Stereo Receiver
Language	English