Kenwood DNX6990HD User Manual

7070 71
Return to the Top page
Bluetooth Operation
Return to the Top page
Bluetooth Operation
Receiving a call
1
Touch [ ] to answer a phone call or
[ ] to reject an incoming call.
NOTE
• While monitoring the camera view, this screen
does not appear even if a call comes in. To display
this screen, press the <TEL> button or return the
shift knob of car to the driver position.
Operations during a call
Adjust the receiver volume
Press the <∞> or <5> button.
Turn the volume knob.
Switch the voice output
Touch [
] to switch the voice output
between phone and speaker.
Output the dial tone
Touch [DTMF] to display the tone input screen.
You can send tones by touching desired keys
on the screen.
Muting Audio Volume upon Reception
of Phone Call (DNX5190 only)
Whenacallisreceivedoryouansweracall,
theCallInterruptscreenappearsandsystem
ispaused.
Thesystemresumesplayingautomatically
whenthecallendsandhangupthephone.
NOTE
• To use the Mute feature, you need to hook up the
mute wire to your telephone using a commercial
telephone accessory. See “Connection” (P.27) in
Quick Start Guide.
Call waiting
Ifyoureceiveacallduringanothercall,you
canansweritwiththecurrentcallsuspended
orswitchbetweenthecurrentcalland
waitingcall.
Answer the new incoming call
Touch [
]. The current call is kept suspended.
Switch between the current and waiting call
Touch [ ] again.
Each time you touch [
], the calling party is
switched.
Terminate the current call
Touch [
].
The call switches to the waiting one.
Bluetooth Setup
YoucanregisterPINcode,selectthedevice
toconnect,andperformoutputsetup.
1
Press the <TEL> button.
Hands Free screen appears.
2
Touch [BT SETUP].
Bluetooth SETUP screen appears.
See the following section for each setting.
• Register the PIN code (P.72)
• Select the unit to connect (P.66)
• Set up output (P.72)

Kenwood DNX6990HD Specifications

General

Brand	Kenwood
Model	DNX6990HD
Category	Car Navigation system
Language	English