24
ENGLISH
TROUBLESHOOTING
Symptom Remedy
General
Sound cannot be heard.
•
Adjust the volume to the optimum level.
•
Check the cords and connections.
“MISWIRING CHECK WIRING
THEN PWR ON” appears.
Turn the pow er off, then check to be sure the
term inals of the speaker wires are insulated properly.
Turn the pow er on again.
“PROTECTING SEND SERVICE”
appears.
Send the unit to the nearest service center.
•
Sound cannot be heard.
•
The unit does not turn on.
•
Information show n on the
display is incorrect.
Clean the connectors.
( 30)
The unit does not work at all. Reset the unit.
( 3)
Radio
•
Radio reception is poor.
•
Static noise while listening
to the radio.
Connect the antenna firmly.
USB/iPod
“READING” keeps flashing. Do not use too many hierarchical levels or folders.
Elapsed playing time is not
correct.
This is caused by how the files are recorded.
“LOADING” appears when you
enter search mode by pressing
.
This unit is still preparing the iPod/iPhone music list.
It may take som e time to load, try again later.
Correct characters are not
displayed (e.g. album name).
•
This unit can only display uppercase letters,
num bers, and a limited num ber of sym bols.
•
Depending on the display language you have
selected
( 5)
, some characters m ay not be
displayed correctly.
“NA FILE” Make sure the media contains supported audio files.
( 30)
Symptom Remedy
USB/iPod
“NO DEVICE” Connect a USB device, and change the source to USB again.
“COPY PRO” A copy-protected file is played.
“UNSUPPORTED DEVICE”
appears.
•
Check whether the connected device is compatible w ith
this unit and ensure the file systems are in supported
formats.
( 30)
•
Reattach the device.
“UNRESPONSIVE DEVICE”
appears
Make sure the device is not m alfunction and reattach the
device.
“USB HUB IS NOT
SUPPORTED” appears.
This unit cannot support a USB device connected via a
USB hub.
•
The source does not
change to “USB” when
you connect a USB
device w hile listening
to another source.
•
“USB ERROR” appears
The USB port is draw ing more pow er than the design limit.
Turn the pow er off and unplug the USB device. Then, turn
on the pow er and reattach the USB device. If this does not
solve the problem, turn the pow er off and on (or reset the
unit) before replacing w ith another USB device.
“NO MUSIC” Connect a USB device that contains playable audio files.
“iPod ERROR”
•
Reconnect the iPod.
•
Reset the iPod.
ANDROID
•
Sound cannot be heard
during playback.
•
Sound output only
from the Android
device.
•
Reconnect the Android device.
•
If in
[HAND MODE]
, launch any media player
application on the Android device and start playback.
•
If in
[HAND MODE]
, relaunch the current media player
application or use another media player application.
•
Restart the Android device.
•
If this does not solve the problem, the connected
Android device is unable to route the audio signal to
unit.
( 30)