TK-760/762
OPERATING
FEATURES
/INSTALLATION
1-5. Clone
Mode
(Figure
21
Programmed data
is
transferred from one trans-
ceiver to another by using a microphone cable.
1.
Connect the master set to the slave set
with
but the
master set
is
TK-760 only.
2.
Turn the slave set on.
3.
Hold down the
CH
[Tj
key, turn the master set on,
and keep the
CH
[Tj key down for
two
more sec-
onds. "-C-" appears on the display to indicate that
clone mode has been entered.]
INSTALLATION
1.
Accessory Connection Cable
(KCT-19 : Option)
The KCT-19
is
an
accessory connection cable for
connecting external equipment. The connector has
15
pins and the necessary signal lines are selected for
use.
1-1. Installing
the
KCT-19
in
the
transceiver
1.
Remove the upper and lower halves of the trans-
ceiver case, and lift the
DC
cord bushing (
0)
from
the chassis.
2.
Remove the pad
(f)
I.
Fig. 2
4.
Press the MON key
on
the master set. The
~
mark
appears and data
is
sent from the master set
to
the
slave set. "-PC-" appears
on
the slave set to
show
that it
is
receiving data.
5.
When cloning
is
complete, the
~
mark
on
the mas-
ter set disappears
and
"-C-" changes to
"END".
The
slave
set
is
automatically reset and enters user
mode.
If cloning fails, the master set shows "ErrOr".
Re-
peat steps 4 and
5.
If you wish
to
clone several sets, switch each
of
them on and repeat 4 and
5.
Fig. 1
7
This Manual: http://www.manuallib.com/file/2593611
To Next Page
Loading...
Need help?
General
